Solid carbide roughing Spiral Bit 2 flute Down Cut

Solid carbide roughing Spiral Bit 2 flute Down Cut (STC)

• Solid Tungsten Carbide (STC) Roughing Spiral Bit upcut with 2 negative spiral fluted cutting edges. Down cut refers to the direction of the flute.
• As the router bit grooves, slots and cuts the chips are forced downwards. Therefore, the best finish is on the topside of the cut part. The downwards chip flow also assists in holding the material in place.
• For cutting, format cutting, copying, circumferential milling and trimming, of Softwood and hardwood, chipboard, MDF, plywood, duromers, plastomers, mineral materials with high feed speeds.
• Use in chucks or collet chucks on routers and CNC machines. Ensure that the workpiece is well clamped, feed speeds should be reduced due to the increase of pressure on the tool.
• For the production of the Solid carbide roughing Spiral Bit 2 flute Down Cut (STC) we exclusively use high-quality finest grain solid tungsten carbide from leading manufacturers.
• The milling Spiral Bits are designed with 2 centre cutting edges, with a plunging facility and are also suitable for drilling, ramping and circular dipping.

Technical Information about the Solid Carbide 2 Flute Roughing Spiral Bit Down Cut 

• D = Cut Diameter
• l = Cut Length
• L = Overal length
• S = Shank Diameter
• PWWU Order number: S10109
• Recommended speed: 18000 - 24000 rpm.
• Feed rate: 2 – 10 m / min (depending on the depth of the cut and the diameter of the tool)
• Made of finest grain solid tungsten carbide (STC)
• Cylindrical, smooth shank
• 2-edged, negative spiral fluted cutting edges – down cut
• This material is capable of cutting Softwood and hardwood, chipboard, MDF, plywood, duromers, plastomers, mineral materials
• Also ideally suited for demanding use in CNC machines
• Made in Germany! Quality from German production, exclusively produced for pwwu24.de by Präzisionswerkzeuge Wurzen
• Ground and flank cutting.
• The face cutting edge geometry with 2 centre cutting edges is suitable for plunging and drilling.
• Multiple regrinding is possible due to wide cutting edges
• The delivery takes place in stable plastic packaging

Poor finish can occur if your tool is run too quickly or too slowly. It is important to optimize your tooling speed dependent on your job.

On request we can also produce special dimensions! If required, we adapt the cutting geometry to your application.

We can also sharpen your Solid Carbide Roughing Spiral Bits. The sharpened Roughing Spiral Bit only receive our original manufacturer's grinding here. The tools will then be returned to you in new tool quality.