Straight turning tool right 32 x 32 DIN4971 ISO1 P30 - P50

Tungsten Carbide Brazed Tip Lathe turning tool right 32 x 32 x 175 mm, P30 - P50 DIN 4971, ISO 1, Carbide - equipped with P30 - P50

Unused Carbide Brazed Tip Lathe turning tool right with traces of storage as well as slight discoloration or color damage from a storage resolution.

The Straight turning tool right 32 x 32 DIN4971 ISO1 P30 - P50 is equipped with a diamond ground carbide cutting edge!

Technical data Carbide Brazed Tip Lathe turning tool right DIN 4971 32 x 32 x 175mm, tungsten carbide - equipped with P30

• Shank height: H = 32 mm
• Shank width: W = 32 mm
• Total length: L = 175 mm
• Design: With brazed carbide cutting tip
• PWWU24 Order number: S1006.40
• Solder Plate Type: A20
• Quality: Tungsten Carbide - grade P30 - P50

Operating conditions for Tungsten Carbide grades P30 and P30 S:

Tungsten Carbide grades P30 and P30S are suitable for turning steel, cast steel and long-chipping malleable cast iron at medium to low cutting speeds. The cutting speeds can therefore be about 50% lower than when using K10. P30 can be used at feed rates of up to 2.5 mm / rev, even under unfavourable conditions. (with uneven material: e.g. with cast and forged crust, changing hardness etc., changing cutting depths, interrupted cuts, as well as not vibration-free working). This carbide grade can also be used with round chisels for milling, planing and further drilling of steel, cast steel and long-chipping malleable cast iron.

Operating conditions for Carbide grades P40 and P40 S:

The Tungstencarbide grades P40 and P40 S are suitable for turning steel and cast steel, also with sand inclusions and blowholes, at low cutting speeds. (The cutting speeds can therefore be about 60% - 70% lower than when using K10.) Can be used with feeds of up to 3 mm / rev and large chip cross sections, especially under unfavourable conditions. This can mainly be caused by uneven material: e.g. cast and forged crust, varying hardness, varying cutting depths, interrupted cuts, not vibration-free working, etc. Large rake angles can be achieved with this carbide grade. It can also be used for planing and shaping steel and cast steel, especially for heavy cuts. P40 is also suitable for use in older planing machines and partly also for automatic work, with boring bar, boring head or milling head.

Operating conditions for the carbide grades P50 and P50 S:

Tungsten Carbide grades P50 and P50S are suitable for turning steel and cast steel, also with sand inclusions and blowholes, at low cutting speeds. The cutting speeds can therefore be about 70% - 75% lower than when turning with K10. Can be used with feeds of up to 4 mm / rev and large chip cross sections. Particularly suitable for the most difficult cutting conditions. This can mainly be caused by uneven material: e.g. cast and forged crust, changing hardness, changing cutting depths, interrupted cuts, not vibration-free working, etc. Large rake angles can be achieved with this extremely tough carbide grade. It is also suitable for use on older lathes and for automatic work with boring bar, boring head or milling head. In addition, it can be used for planing and butting steel and cast steel even under the most difficult cutting conditions.