Straight turning tool right 20 x 20 P30 DIN4971 ISO1

Carbide Brazed Straight Turning Tool right 20 x 20 x 132 mm, P30 DIN 4971, ISO 1, carbide - equipped with P30 

Unused Straight turning tool right 20 x 20 P30 DIN4971 ISO1 with traces of storage as well as discolouration and colour damage due to storage dissolution.

Equipped with diamond ground carbide cutting edge!

Technical details: turning tool straight right DIN 4971 20 x 20 x 132mm, carbide - equipped with P30

• Shank height: h = 20 mm
• Shank width: b = 20 mm
• Total length: L1 = 132 mm
• Design: with soldered diamond ground carbide cutting insert
• Solder Plate Type: A16
• clearance angle α = 6°
• Wedge angle β = 72
• rake angle λ = 12°
• Quality: Carbide - grade P30 - P50

Turning tool right Sketch:

Operating conditions for Carbide grades P30 and P30S:

The carbide grades P30 and P30S are used for turning steel, cast steel and long-chipping malleable cast iron at medium to low cutting speeds. (The cutting speeds can be about 50% lower than when using K10.) This carbide grade can be used with feeds of up to 2.5 mm / revolution, even under unfavourable conditions. This means when used in uneven materials. These can be, for example, cast and forged crusts. Materials with varying hardness are also included. However, this type of carbide is also suitable for use with varying cutting depths, interrupted cuts and for work that is not vibration-free. This carbide grade can also be used for milling, planing and drilling steel, cast steel and long-chipping malleable cast iron.